HMDS and adhesion promotion

Resist that lifts during development, or features that wash away at the edges, nearly always point to poor adhesion. The cause is usually water. Oxide and glass surfaces hold a layer of adsorbed moisture that the resist can’t bond to. Dehydrating the surface and then priming it with an adhesion promoter such as HMDS (hexamethyldisilazane) solves most adhesion problems.

What HMDS does

HMDS reacts with the hydroxyl groups on an oxide surface and replaces them with methyl groups. The surface changes from water-loving to water-repelling, so the resist wets and bonds to it and developer can’t creep underneath. A correct prime is a single molecular layer. More HMDS doesn’t help, and too much causes its own problems.

Vapour priming

The most reliable method is vapour priming. The substrate is dehydrated, then exposed to HMDS vapour while warm, typically somewhere between about 75 and 150°C depending on the system. Vapour priming gives an even monolayer with no excess liquid, and the treated surface stays hydrophobic for longer: around two weeks for vapour-primed wafers, against a few days for spin-primed ones.

Vapour priming is done in a vacuum oven, in a dedicated prime module, or in a sealed chamber on a hotplate. An HMDS bake plate combines the dehydration bake and the vapour prime in one step.

Avoid spin-on HMDS in the coater

Spinning or puddling liquid HMDS onto the substrate seems convenient, but it leaves far more than a monolayer. Excess HMDS reacts with the resist, can leave residue that won’t develop out, and contaminates the coater bowl. If you must prime with liquid, do it away from the resist coater and bake the substrate afterwards.

Checking the prime

A water contact angle measurement is the quickest check. Targets in the literature vary: some labs aim for 65 to 80°, others recommend matching the substrate’s angle to the resist’s, often 45 to 60°. Agree a target for your resist and measure it regularly, especially after a change of HMDS bottle or tool.

Over-priming

Too much HMDS makes the surface so hydrophobic that the resist dewets, pulling back into islands or leaving bare patches during the spin. If that happens, reduce the prime time or temperature.

Noble metals

HMDS bonds to hydroxyl groups, so it does nothing on gold, platinum and similar metals. On those surfaces, a thin adhesion layer such as titanium or chromium under the noble metal, or a different primer designed for metals, is the usual answer. Specialist adhesion promoters are also available for other difficult surfaces.

A good priming routine

  1. Clean the substrate.
  2. Dehydration bake, around 120°C or more for oxides and glass.
  3. Vapour prime while warm.
  4. Let it cool, then coat promptly.

Our bakes guide covers the dehydration bake.

How SiSTEM can help

CEE make an HMDS vapour prime version of the Apogee 200 bake plate, which dehydrates and primes substrates in a sealed chamber on the plate, next to the coater. Tell us your substrates and resist, and we’ll work out whether it suits your process.

More technical guides

All technical guides