Technical guides
Practical guides to spin coating, baking, developing and temporary bonding, written by Mark van den Berg, Senior Sales Engineer at SiSTEM. They draw on CEE’s process know-how, resist makers’ guidance and our own experience supporting labs across the UK and Europe.
For published papers, theses, patents and cleanroom procedures that use CEE equipment, search our research library.
Spin coating
- Spin coating theory – How a spin coat works, how speed and acceleration set the film thickness, and how to build a recipe.
- Spin coating defects: causes and fixes – Comets, striations, swirls, pinholes, chuck marks and fibres, with the likely cause and fix for each.
- Edge bead removal and backside rinse – Why the edge bead forms, why it matters, and how solvent, optical and manual removal and backside rinse work.
- Dispensing for spin coating – Volumes, static and dynamic dispense, keeping bubbles out, choosing a dispense method and fixing a dripping tip.
- Coating squares, slides and photomasks – Corner build-up, recessed chucks, speed limits and what to plan for with photomasks and thick glass.
- The cotton candy effect – Why some materials leave the substrate as fine fibres, which ones do it, and the recipe and hardware changes that stop it.
- Spin coating thick films – Dispense, slow spread steps, edge bead, multiple coats and baking thick layers without cracks.
- Choosing a spin chuck – Vacuum chuck sizing, materials, porous chucks for thin wafers, captive and recessed chucks, and when to go custom.
- Spin coating under nitrogen and in glove boxes – Nitrogen bowl purge or glove box, antisolvent timing for perovskites, and controlling humidity.
- How to choose a spin coater – A buyer’s checklist for the UK and Europe, from substrates and chemistry to CE marking and support.
Baking and priming
- Hotplate or oven – How each one heats a resist film, and what that means for skinning, bake time and uniformity.
- The bakes in lithography – Dehydration, softbake, post-exposure and hard bakes, with typical settings and what goes wrong.
- Bake methods and ramping – Vacuum contact, gravity contact, proximity baking and programmable lift pins for staged bakes.
- HMDS and adhesion promotion – Why resist lifts, how vapour priming works, contact angle targets and what to use on noble metals.
Developing and lift-off
- Developing photoresist – Developers, puddle versus spray versus immersion, rinse and dry, and common development faults.
- Metal lift-off – Undercut profiles, bilayers, resist thickness rules, deposition and getting the metal to lift cleanly.
Temporary bonding and debonding
- Why wafers are temporarily bonded – Where temporary bonding is used and how the bond and debond process flows.
- Temporary bonding adhesives and carriers – Adhesive types and temperature limits, glass, silicon and sapphire carriers, voids and TTV.
- Debonding methods compared – Thermal slide, mechanical peel, laser and solvent release compared on cost, speed and stress.
- Bonding compound semiconductor wafers – Thermal expansion mismatch, brittle wafers and gentle ramps for InP, GaAs and similar materials.
Workstations and compliance
- Planning a lithography workstation – Ducted or recirculating exhaust, face velocity, yellow light, containment, utilities and LEV testing.
- CE, UKCA and NRTL explained – What each mark means for process equipment in the UK and Europe, and what changes in 2027.
Reference
- Glossary – Short definitions of the terms used across the guides, from acceleration to TTV.
Need help with a process?
Send us your material, substrate and recipe, and we’ll work through it with you and CEE’s process team. You can also see our spin coaters, bake plates, spin developers and temporary bonding and debonding tools.