Hotplate or oven: choosing how to bake photoresist
Every resist process includes at least one bake, and the first decision is what to bake it on. Hotplates and convection ovens both reach the temperature on the datasheet, but they get the heat into the film in opposite directions, and that changes how the film dries, how long it takes and how repeatable it is.
How each one heats the film
- A hotplate heats from below. Heat passes from the plate through the substrate into the bottom of the film, so the film dries from the substrate upwards and solvent escapes through a surface that stays open until last.
- An oven heats from the outside in. Warm air reaches the top of the film first. The surface dries and skins over while solvent is still trapped underneath, and the solvent then has to work its way out through the skin.
For thin films the difference is small. For thick films it matters a great deal. A skinned surface traps solvent, which can cause bubbles, poor adhesion, wrinkles or popping during exposure, and SU-8 makers advise against softbaking in an oven at all.
Time
A hotplate brings a wafer to temperature in seconds, so a typical softbake takes about a minute. A convection oven heats the air, then the substrate, and the bake usually runs much longer. Published figures vary, from a few minutes extra to half an hour or more. The longer the bake, the more the oven’s slow warm-up and cool-down become part of the process.
Uniformity and repeatability
A good hotplate holds a tight temperature across its surface, and each wafer gets exactly the same bake because it’s baked on its own. An oven bakes a batch at once, but the temperature varies with position in the chamber, with how full the oven is and with how long the door was open. Note that the film on a hotplate runs a few degrees cooler than the plate itself, especially in proximity mode, so set temperatures should come from the process recipe, not from the datasheet alone.
Throughput
Ovens win on batch size. If a process needs a long, gentle bake on many wafers, such as some hard bakes and cures, an oven can be the practical choice. Hotplates handle one substrate at a time, but a short bake soon catches up, and a workstation with a coater and a hotplate side by side keeps each wafer moving.
Where each one fits
| Bake | Usually done on |
|---|---|
| Dehydration bake | Hotplate or oven |
| Softbake | Hotplate |
| Post-exposure bake | Hotplate, for tight temperature control |
| Hard bake | Hotplate or oven |
| Long cures (polyimide, some epoxies) | Oven, often under nitrogen, or a programmed hotplate |
Our guide to the bakes in lithography covers each one, and our guide to bake methods and ramping explains contact and proximity baking on a hotplate.
How SiSTEM can help
Apogee bake plates give tight uniformity across the plate, contact and proximity baking and programmable lift pins for ramped bakes, on the bench or in an X-Pro II workstation beside a spin coater. Tell us your materials and bake steps, and we’ll recommend the set-up.